Why You Need a Ghost 2 Immobiliser Fitting Near Me
Modern day thieves can take vehicles in just a minute. They use the OBD port of the car to hack into the ECU and then duplicate a key, all using a laptop that is hidden inside the vehicle.
The Autowatch Ghost immobiliser can prevent this by sending pin codes to the buttons on your vehicle (steering wheels and central console). It is completely inaccessible to anyone else in your vehicle.
No key fobs, or LED indications to give away its location
If you're looking for a method to stop keyless entry theft or key cloning then look no further than the ghost immobiliser. This device safeguards your vehicle from these kinds of attacks by blocking the engine after a valid pin code has been entered. This is an extremely efficient method of protecting your car, and insurance companies see it as a precautionary measure that could help lower the cost of your insurance.
The audi rs6 ghost installer (
killer deal) is connected to the CAN data network of your vehicle. Once installed by Car Theft Solutions, it will only work if you enter your personal code for override and a specific button combination. This means that any attempt to start the vehicle without entering this code will be met with a loud siren, and the engine will not start. The criminal will realize that they've been caught and are likely to abandon the vehicle and escape.
This system has the benefit of not transmitting any signals like a tracker. Thieves can't utilize RF receivers to determine your Ghost unit's location. It also doesn't emit any IR (infrared) signals like the usual remote control key fobs or tracker do, making it very hard to bypass or hack.
Another advantage of the
ghost immobiliser installation is that it has an option for valet parking that can be activated when you hand your vehicle over for valet parking or servicing. This will turn off the CAN immobiliser for 30mph, and enables you to use the vehicle as normal with your key fob or smartphone app. If the vehicle is parked up again the Ghost will return to full functionality.
If you would like to find out more about the Ghost immobiliser or have us install it in your vehicle, contact us at Car Theft Solutions today. We are a family-owned and run business with over 10 years of experience in security for vehicles including the Ghost immobiliser fitting. We are a Thatcham certified installer of
ghost alarm installation products and have built our brand on the basis of customer satisfaction.
No cloning or hacking
The
autowatch ghost installer Ghost immobiliser is one of the most advanced models available. It protects your vehicle from hacking and key cloning, making it nearly impossible to take. The only method to steal your car is physically tow it away. Even then, they won't be able to start the engine.
This is because unlike other immobilisers that only stop your vehicle from starting if they don't have your fob this innovative system actually cuts off the engine control unit so that the vehicle can't start. The system communicates an alert via buttons on the steering wheel, door panel, or the centre console. It can only be disarmed with the correct pin code configuration.
Its sleek and discrete design means that it fits in seamlessly into your vehicle, with no additional keys or LED indicators It operates on its own, independent of your factory alarm or tracker. It also functions as a CAN bus immobiliser which means that it sits within the control area network of your vehicle and is not interfering with any other devices such as your vehicle's built in key fob or alarm.
This unique technology isn't visible to thieves, unlike other systems that employ codes and RF scanning. It only sends a series of pin codes silently through the buttons on your vehicle's steering wheels doors, door panels or central console. The
ghost 2 immobiliser problems is a revolutionary device that defends your vehicle against keyless entry and smart key theft by producing an individual, personalized pin code that needs to be entered to disarm it.
With the increasing number of keyless entry cars on the road, thieves are becoming increasingly sophisticated and utilizing cloning devices which can be purchased via classifieds or online for less than PS15. The key fob that is cloned can be used to gain access to the vehicle. The standard immobiliser can only stop the car from starting if the thief has your original key fob. This isn't enough protection and it's not difficult for criminals jam or spoof signals to unlock your vehicle.
Valet mode
A standard immobiliser fitted to your vehicle uses an electronic chip that sends the signal when you hit your key fob button. The system then searches for the specific code that was sent from the key to start the car. If the correct signal isn't detected, it will cut off the signal and prevent the engine from getting started. This is the basis of all immobilisers that are sold aftermarket. It's a crucial step to protect your vehicle from being taken away, even if someone has your keys or an accessory that can boost the signal of your key fob.
However, a ghost immobiliser does not only stop it from happening however, it goes far beyond that. The system, located on the CAN Bus of your Mercedes is programmed with a unique pin code that needs to be entered to start the car. It is then secured on your app, and no one can ever access it unless they have the same pin number that you have.
The system will also stop signal jamming, cloning and hacking (which thieves could use to bypass the immobiliser on your vehicle). If a burglar gets their hands on the keys to your car or fob, they won't be able start your vehicle even if it is located nearby. They may only be able to steal your car on a flatbed truck and that's highly unlikely.
Valet mode is an option with your ghost immobiliser. When it is activated the car's glove box and trunk will be locked to ensure that anyone who steals your car will not have any personal items to take with them. It will also limit the speed of your Tesla so it can't be driven over 70mph. It also will disable absurd modes. It will also block your driver profiles and hide your home / work addresses so that no one other person can access your personal data on your Tesla dashboard.
If you would like to use your vehicle for valet parking, or for service, select the 'Valet/Service' mode on your dashboard app. Enter your 4-digit valet code onto the touchscreen. Once you have done this the alarm functions will be disabled, but it will still block the ability to start your
car stolen with ghost immobiliser without a valid pin entered. This is ideal for those who need to give their vehicle over to others like taxi drivers and garage mechanics.
The first aftermarket CAN bus immobiliser for the world
The Autowatch Ghost offers unparalleled security and is the first aftermarket CAN-bus immobiliser available in the world. It safeguards you from key cloning and hacking and even the theft of keys. This is done by utilizing your vehicle's current interface. It doesn't require any additional remotes or fobs and instead works with the vehicle's data network CAN. This makes it a 'stealth device.
The device is a circuit board that is hidden in your car's engine control unit (ECU). It functions quietly. Once activated, it will stop the car from starting unless you enter a PIN. This is the code you receive when you request an installation. This number is required to activate valet, disable the alarm, or let you to leave in a vehicle belonging to a family member (if they also have Ghost installed).
It is designed in a way that it is not spotted by anyone who is looking into your cars interior, does not send any radio signals, and is only heard when it's being activated. It can be fitted in a variety places, making it virtually impossible to spot.