Peugeot 308 Key Fob
replacement key for peugeot 107Peugeot's 308 could be catching on a bit, but it still feels eye-catching. It might not be the plushest car in its class but a Ford Focus or Volkswagen Golf will protect you from surface imperfections - however, it's a comfortable and pleasant driving experience.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. No matter if the issue is intermittent or constant these tips will assist.
Water Damage
If you happen to leave your key fob in a puddle or get it wet when kayaking, swimming, canoeing, rafting or canyoning, it's likely to suffer water damage. The best way to stop this from happening is to always keep it in a dry bag when you're outside or performing activities in which the fob may be exposed to high levels of water.
You'll also want to make sure that the fob is completely dry prior to opening it and reusing it. If you smell any odors from the fob (such as industrial fluid or windshield washer fluid) This is a further sign that it has been submerged.
A circuit board that is wet could cause the battery to discharge its charge or even explode. If you can get your keyfob 308 from the water, turn the button side up and shake as much water out as you can before opening the casing. After you open it, take out the battery and clean the circuit board using a cotton swab dipped in 90 percent isopropyl alcohol.
Other reasons why your Peugeot 308 remote entry keyless system might not function include a dead coin cell battery or receiver module issue signal interference, or a defective chip. If none of the above are the issue you can restart the system by disconnecting 12 volt battery from your car for 15 minutes.
Dead Coin Battery
Peugeot cars come with remote start that lets drivers start their vehicle from an extended distance, which allows them to warm up or cool down the car before they get in. This feature is very useful particularly during the cold winter months. But sometimes, the remote stop system stops working due to a variety of reasons, such as the battery in the coin is dead.
The coin-shaped battery contained inside the key fob can last between two and four years based on how often it is used, the location it was purchased, and how it is utilized. The date for use-by will be printed on the packaging or mentioned in the user manual.
If the key fob stops working after exposure to clean tap water it is recommended to remove the battery, clean the chip with a paper towel and isopropyl Alcohol, then dry it thoroughly before replacing it. If the key fob was exposed to soapy or salty water, it could have caused the chip to become damaged. You'll need to replace it.
If you're unsure if the battery is defective, you can check the voltage using a multimeter that is connected to both the terminals for plus and minus. If the voltage is lower than 12-13 volts, then you need to replace the battery. Alternately, you could try to reset the on-board computer by disconnecting the 12 volt battery for a few minutes, and then reconnecting it in reverse order (positive cable first and then negative). The engine should now start.
Faulty Receiver Module
If you're unable to see the "Key Detected" message on your dashboard, it's possible that the receiver module has created a fault. It's the component that sends an alert to the car when the key fob is activated it also acts as an immobiliser, and stops it from starting until the correct key is used.
The cause could be various reasons, such as water damage or just the aging process. If your
Peugeot 308 key fob was exposed to dirty tap water, for example the electronic chip located inside the device will be damaged. In this instance you'll need to remove off the battery and thoroughly clean it with isopropyl alcohol, or electronic cleaner. Once the battery is dry you can try it again.
If the issue persists then it's a good idea to visit an area Peugeot specialist or locksmith. They can employ the diagnostic tool to pinpoint the problem and fix it.
The loss of your Peugeot keys to your car can be a stressful experience. A qualified auto locksmith can solve the issue in a matter of minutes. They can program your car and cut a fresh, working key for you. Click here to find a local locksmith near you.
A malfunctioning electronic chip
The electronic chip in your Peugeot 308 key fob is a very important component of the remote control system. If it becomes damaged, your car might not start or receive a message that reads "anti-theft active". In this case the only option is to replace the key. Auto locksmiths who are professionals are able to provide this fastest possible time.
The chip inside the chip of your Peugeot 308 key fob can be damaged due to sweat, water damage, dirt or other reasons. If your
peugeot 2008 key fob 308 key fob has been exposed to soapy water, it is recommended to cleanse it immediately. You can clean the electronic component using paper towels soaked with isopropyl Alcohol. The battery must then be allowed to dry completely.
Radio interference can cause the key fob to stop functioning. This could be due to other devices use the same frequency as your
peugeot 308 key fob replacement keyfob. This could be due to poor conditions or objects close to the vehicle. It is recommended to visit a
peugeot 407 key fob dealer if you encounter this issue.
The
peugeot 2008 key fob not working 207/308 key fob is very delicate and requires extra attention. It should not be dropped or throw it around. If you lose it, try to find it as quickly as you can. You can reset your on-board computer by disconnecting the battery for a couple of minutes. Disconnect the negative cable before the positive.
